2,540 Brands 528 Categories All Departments
Government Export Restriction Government Export Restriction
Lee Production Pot IV Electric Melter90009
$69.99 $79.98 Save 12%
Code: LEE-RBM-90009
MPN: 90009
UPC: 734307900090

Lee Production Pot IV Electric Melter Product Info

Lee Precision Production Pot IV Electric Melters 90009 are the fast and efficient way to melt down your casings for resizing and reuse. These large gunsmith and reloading tools are capable of holding approximately ten pounds of led. Lee Precision has manufactured the Production Pot 4 with infinite heat control and a short melt time of around twenty minutes, leaving you more time to perform more delicate reloading tasks. The Lee Production Pot 4 Reloading Melter takes only 500 watts of power to heat up, and once it's at the temperature you want, it will stay that way with little energy cost. These Lee Precision reloading tools have a front-mounted pouring spout so you can see where your molten lead is going, and the melter is capable of reaching up to 900 degrees Fahrenheit. The melting pot is mounted to a wide, stable base, and its 4 inches of clearance are more than enough for most bullet and sinker molds. For an energy-efficient melting pot that will melt down your casings quickly and effectively, equip your workbench with the Lee Precision Production Pot IV 10-Pound Electric Melter.

Specifications for Lee Production Pot 4 Casing Melter:

Capacity: 10 pounds
Clearance: 4"
Melt Time: <20 minutes
Weight: 3.93 lbs

Features of Lee Production Pot IV Electric Reloading Melting Pot:

  • Efficient gunsmith tool for melting brass and casings by Lee Precision
  • Can melt up to 10 pounds of lead
  • Less than 20 minute melt time
  • Capable of reaching 900°F
  • Infinite heat control
  • Front-mounted pour spout
  • Uses only 500 watts of power during heat-up
  • 4" of clearance accepts most bullet molds and sinker molds

Package Contents:

  • Lee Precision Production Pot IV Electric Melters 90009

Lee Production Pot IV Electric Melter 90009 Comments

Customer Reviews
Helpful Positive Review It Melts the Lead by Legacy Reviewer, April 24, 2013
Hadn't had a chance to actually cast any lead yet but I did stick a few lbs of lead in it and melt them. They seemed to melt relatively fast. There was a good bit of smoke as to be expected. There isn't a rest at the bottom to rest your molds on like...
1/1 found this helpful
Read 1 Review