The knob of the PVS 14 came off and will go back on but and operate then fall off when turning off where the knob is in neutral. Where shall I send it as ITT has not responded regarding repair information. Or is there a kit for what is likely a common problem. The repair apparently depends on a small steel washer, quite thin that will no longer hold the resistance the spring causes.
Thanks in advance for your attention.
Roger Williams
r1j1@aol.com
ITT PVS 14 generation 3 needs repair
2 posts
• Page 1 of 1
ITT PVS 14 generation 3 needs repair
by roger williams on Tue May 06, 2008 3:42 pm
- roger williams
- Posts: 1
- Joined: Tue May 06, 2008 3:31 pm
by Ryan_W on Tue May 06, 2008 4:24 pm
Hi,
You might want to give Morovision a call. They are the primary ITT distributor and contact in the US.
You might want to give Morovision a call. They are the primary ITT distributor and contact in the US.
Best regards,
Ryan W.
Forum: http://www.opticsplanet.com/msgboard
Blog: http://blog.opticsplanet.com/
Store: http://www.opticsplanet.net/
Phone: (800) 504-5897
Fax: (847) 919-3003
Ryan W.
Forum: http://www.opticsplanet.com/msgboard
Blog: http://blog.opticsplanet.com/
Store: http://www.opticsplanet.net/
Phone: (800) 504-5897
Fax: (847) 919-3003
- Ryan_W
- Site Admin
- Posts: 481
- Joined: Wed Jun 27, 2007 7:50 am
2 posts
• Page 1 of 1
