eotech/3x magnifier mounting

enavarro544 · Guest

I have a eotech and the 3x magnifier, but when I mount both units together my sight picture thru the magnifier puts the red recticle to the right instead of the center. My zero is good, Also I want to raise my eotech, so that when I see thru the magnifier I don't get upper part of the eotech in my sight picture.

Ryan_W · Site Admin Joined: 16 Jun 2003 Posts: 331

I have not personally mounted the two together but I have used them together. The mount for the magnifier is adjustable, so you should have a little room to play with. The magnifier will always sit a hair higher than the sight, but it sounds like you should have some room to lower it a bit. As for side to side, I'm not sure if it adjusts that way. Anybody else have a similar experience?
_________________
Best Regards,

Ryan W.

Forum: http://www.opticsplanet.com/msgboard
Blog: http://blog.opticsplanet.com/
Store: http://www.opticsplanet.net/

Phone: 847-513-6201
Fax: 847-919-3003

Steven-L · Joined: 01 Jun 2006 Posts: 839

The mounts are adjustable for windage and elevation. It's a couple of small slotted screws. It's also in the instruction manual. A riser isn't needed, but we do have one with a rear sight built in. It's the 9-RRA-DOM.
_________________
Aim Hard!

Steve at OpticsPlanet
www.opticsplanet.net

Guest · Posted: Thu Feb 14, 2008 4:23 pm Post subject:

The Magnifier has a silver screw that will allow you to "center" the reticle inside of the magnifier. it doesn't adjust your zero, just your magnifier window.