Products
2,497 Brands 483 Categories All Departments

eotech/3x magnifier mounting

Post a reply


Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:D :) :( :o :shock: :? 8) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :wink: :!: :?: :idea: :arrow: :| :mrgreen:
BBCode is ON
[img] is OFF
[flash] is OFF
[url] is ON
Smilies are ON
Topic review
   

Expand view Topic review: eotech/3x magnifier mounting

Post by Guest on Thu Feb 14, 2008 4:23 pm

The Magnifier has a silver screw that will allow you to "center" the reticle inside of the magnifier. it doesn't adjust your zero, just your magnifier window.

Post by Steven_L on Fri Nov 09, 2007 5:05 pm

The mounts are adjustable for windage and elevation. It's a couple of small slotted screws. It's also in the instruction manual. A riser isn't needed, but we do have one with a rear sight built in. It's the 9-RRA-DOM.

Post by Ryan_W on Fri Nov 09, 2007 4:27 pm

I have not personally mounted the two together but I have used them together. The mount for the magnifier is adjustable, so you should have a little room to play with. The magnifier will always sit a hair higher than the sight, but it sounds like you should have some room to lower it a bit. As for side to side, I'm not sure if it adjusts that way. Anybody else have a similar experience?

eotech/3x magnifier mounting

Post by enavarro544 on Thu Nov 08, 2007 10:20 pm

I have a eotech and the 3x magnifier, but when I mount both units together my sight picture thru the magnifier puts the red recticle to the right instead of the center. My zero is good, Also I want to raise my eotech, so that when I see thru the magnifier I don't get upper part of the eotech in my sight picture.

Top