2,534 Brands 453 Categories All Departments
Advanced Technology Enfield Scope Mount
Starts at $37.19
Purchase
Browse by Rating
(5 reviews)
Share your Thoughts! Write a Review
Most Helpful Positive Review ATI .303 Enfield #1 Mk 3 Scope Mount ENF0113
Overall fairly well satisfied with the purchase. I thought it fit well in both my #4 enfields. The major thing is that it didn't move and kept it's ze...
Read More...
Sort by
Page
Back
Next

Great mount

by Legacy Reviewer, from United States, CO Written on September 29, 2011
RemainEd zeroed after 80 rounds with a 16x scope on board!...
Would recommend: Yes
2 of 2 found the following review helpful.
Was it helpful to you? Yes / No

ATI .303 Enfield #1 Mk 3 Scope Mount ENF0113

by Legacy Reviewer, from United States, WA Written on April 28, 2011
Overall fairly well satisfied with the purchase. I thought it fit well in both my #4 enfields. The major thing is that it didn't move and kept it's zero. The only two issues I have with it is that of the two front screws, one is angled, hard to start straight, and easy to strip threads on. The solution to this, as I figured out later (after I almost stripped it out), is to simply leave the set screws in. They can be backed out enough to remove and swap guns without total removal. The second issue I have is that the hex head screws at the rear of the base are hard to remove (with light tightning) after they settle and the hex wrench will strip also. These should have been torx, phillips, or anything besides hex head screws.

I thought the price was fair. OP had the best price I could find, but any higher price and it would have been a more antagonistic review.
Pros: Holds zero
Cons: Threads easy to strip in angled screwhole...
Would recommend: Yes
3 of 3 found the following review helpful.
Was it helpful to you? Yes / No

Scope mount

by Legacy Reviewer, Verified Owner from United States, IL Written on February 6, 2011
at the rear of the mount there is a little room "for windage". I call it slop. If overtighten it prevents the bolt from operating smoothly or non operating at all. Simple fix is two plastic washer to take up the slop so that the it can be tighten properly. Finger tight allows for it to become loose after firing 5 rounds. I fabicating the two washers and it works great!!
Pros: Cheap, easy installation.
Cons: Should have tighter tolerances....
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes / No

pleased with the mount

by Legacy Reviewer, Verified Owner from United States, OH Written on January 27, 2011
Even came with an allen wrench.
Pros: solid, good instructions, and easy install
Cons: cannot use iron sights after the install...
Would recommend: Yes
0 of 2 found the following review helpful.
Was it helpful to you? Yes / No

Works Great

by Legacy Reviewer, Verified Owner from United States, KS Written on January 20, 2011
I followed the instructions and now I have a solid scope mount....
Would recommend: Yes
1 of 2 found the following review helpful.
Was it helpful to you? Yes / No
Page
Back
Next

Comments on 5 User Reviews of Advanced Technology Enfield Scope Mount