Products
2,501 Brands 483 Categories All Departments
ATN ThOR 640 2.5x Fast Thermal Imaging Weapon Sight
$7,999.00 $9,199.00 Save 13%
Browse by Rating
(2 reviews)
Share your Thoughts! Write a Review
Sort by
Page
Back
Next

Incredible Image

by Legacy Reviewer, from United States, WA Written on January 10, 2014
This scope absolutely is amazing. I frankly did not expect to be able to see the resolution that I am getting here. Even at 300 yards I am able to make out some pretty impressive details. I tried some target shooting first and you do have to have something warm. I used a cup of warm water in a paper cup that seems to work well.
Tried hunting with it and the experience is out of this world. Easily picking up target from 100 to 200 yards.
Tons of fun that's all I can say.
Pros: Superb Image
Cons: Would be nice if it was a little less expensive....
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you? Yes / No

Are you kidding me?

by Legacy Reviewer, from United States, TX Written on November 21, 2013
I bought the original, top of the line Thor when it first came out. It worked for part of one hunt, until the screws that held the battery door stripped out of the aluminum housing.
They fixed that, but other things went wrong. Then they broke the scope while repairing it and tried to replace it with a new Thor that was 1/2 of the retail value. I pushed and got the scope I'm reviewing. When I first got it, I went to the range, fired - and it turned off. 3 more times, same result. Back to the factory. After repair, it didn't turn off, just rebooted and lost all setting mods. Not only that, but an image of the targets was now permanently showing over the top 1/2 of the screen. Back again. Got it back - didn't reboot, but the image is now mottled and at the lowest brightness setting it looks like it is off. Also, at 8x, the scope was so far off that i couldn't get it on paper at 50 yds; at 2.5x, I could. I normally shoot a 3.5-15x50 Nightforce, and it's reticle barely takes movement from zero to hit dead center at 300 yds, so my picatinny rail is correctly aligned.

So, you may ask, how long did all of this take? Well, we're not done yet, but I bought the scope in January 2011, so just a couple of months shy of 3 years, and I got 2 hours of hunting so far.

Now, I'm not pursing repair anymore. I asked for a new scope this last time and they basically told me to sit on it.

I have been very patient with them. Never threatened, always encouraged them to take w...
Read More...
Would recommend: No
34 of 36 found the following review helpful.
Was it helpful to you? Yes / No
Page
Back
Next

Comments on 2 User Reviews of ATN ThOR 640 2.5x Fast Thermal Imaging Weapon Sight