Products
2,496 Brands 483 Categories All Departments
Hornady Lock-N-Load Power Case Prep Center 050012
$396.49 $577.20 Save 31%
Browse by Rating
(1 review)
Share your Thoughts! Write a Review
Sort by
Page
Back
Next

Hornady Case Prep Center

by Legacy Reviewer, Written on February 5, 2013
Overall this is a great way to process brass. setup for a specific case is less than 5 minutes for pilot installation, shell holder installation and height adjustment. Care must be taken to not apply to much down pressure on the handle as there is some flex in the interface between the main housing and the vertical adjustment. Its easy to trim too short if one applies to much pressure. This unit really saves wear and tear on wrists when cutting and deburring. Having all the stations running at one time allows you to perform all tasks at one time versus setting up for each single process such as cut, inner debur, outer debur, neck brush, and primer pocket.
Pros: Very fast way to process brass
Cons: could have more rigidity in upper sliding portion...
Would recommend: Yes
6 of 6 found the following review helpful.
Was it helpful to you? Yes / No
Page
Back
Next

Comments on 1 User Reviews of Hornady Lock-N-Load Power Case Prep Center 050012