I only had about 300 9mm cases that needed this. When I recieved it it didn't have the bottom part that holds this to the press. The part right under where the shell goes that you slide into the groove on your press. Was just the holder part and about the size of 2 nickles on eachother New to reloading I didn't know this and spent 20 minutes trying to figure it out before I realized it was defective. My other ones came fine. I was able to complete the job by putting the rounds in first and balancing them in place. For sure is just a manufuacturer defect and was not optics planets fault.
Pros: Did the job
Cons: Didnt come as seen in the photo...
Would recommend: No
0 of 0 found the following review helpful.
Was it helpful to you?
You said this review was not helpful.
Would you like to change your vote?