Products
2,501 Brands 483 Categories All Departments
Ruger Weaver Type Scope Base Adapter for Mark I, II, III Handguns 90224
$19.89 $24.95 Save 20%
Browse by Rating
(3 reviews)
Share your Thoughts! Write a Review
Most Helpful Negative Review Not compatible with Fastfire III red dot
All was good until I mounted my new Burris Fastfire III red dot sight. The grooves that run across the Weaver style base adapter are not deep enough ...
Read More...
Sort by
Page
Back
Next

Great looking but there are a few nitpicks

by Lanzer, from United States, CA Written on December 24, 2014
Great looking scope that shows exceptional quality. Perfect if you plan to never remove your scope. Though as a design decision all the rail grooves are rounded instead of squared. If you have scope rings that have square indexes then they won't work with this rail. Secondly, the spacing of the grooves doesnt match the picatinny standard, which means you'll need to move your scopes back and forth if you're moving scopes around....
Pros:
  • Quality
Cons:
  • Non standard
Would recommend: No
0 of 0 found the following review helpful.
Was it helpful to you? Yes / No

Not compatible with Fastfire III red dot

by Legacy Reviewer, Verified Owner from United States, VA Written on February 14, 2013
All was good until I mounted my new Burris Fastfire III red dot sight. The grooves that run across the Weaver style base adapter are not deep enough to fully accomodate the bar acrossthat runs across the clamp of the sight. The sight rocks back and forth and will not sit fully flat on the adapter. I had to file a groove about 20% deeper (1/2 hour job) to get the sight to sit flat and not rock foward and backward. Other base adapters I have used did not pose this problem.
Pros: Nice finish, mounts easily
Cons: Grooves across rail not deep enough...
Would recommend: No
1 of 1 found the following review helpful.
Was it helpful to you? Yes / No

Ruger Weaver-style mount

by Legacy Reviewer, Verified Owner from United States, TN Written on February 8, 2013
If they would put a drop of locktite on the screws prior to packaging,it would help.
Pros: easy to install.
Cons: must have small screw-driver and locktite, ...
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you? Yes / No
Page
Back
Next

Comments on 3 User Reviews of Ruger Weaver Type Scope Base Adapter for Mark I, II, III Handguns 90224