Products
2,558 Brands 529 Categories All Departments
Vortex Riflescope Battery Holder 2032
$14.49 $17.42 Save 17%
Browse by Rating
(7 reviews)
Share your Thoughts! Write a Review
Most Helpful Positive Review Spare battery holder for most scope batteries
Ever have your battery die at the least opportune moment? This holder fits on the picatinny rail and will hold any flat battery that's the size of a ...
Read More...
Sort by
Page
Back
Next

Not what I expected from vortex

by Toby, from United States, TX Written on April 7, 2015
For a couple years now I have come to believe that Vortex meant value. They may not make the very best on the market but you're going to get a high quality, high value piece that won't break the bank. I use everything from the Razor HD 2 down to a crossfire and I've been happy with the quality for what I paid...until this product. Its all polymer and the finish is passable at best. Lots of rough edges. Locks on the rail with that little cut out you see in the picture and the fit, again, is passable. The fit isn't really very tight but since it is all polymer, it doesn't make any noise or anything. I'm not sure how water proof its going to be, the washer is a very hard, flat rubber, it doesn't seem to compress much at all, I will probably replace it with a Viton O-ring out of my harbor freight set in hope of keeping the battery fresh. The little cable you see on it to keep you from losing the lid is again, kinda disappointing. Its nice its there so you don't lose the lid, but, it just has a loop on the end you can't see in the picture. The picture on the packaging after you receive the product shows you looping it through a harris style bipod. You could loop it through holes in your rail or something too if you're using this on and AR style rifle. Personally, I would much rather see the little cable attach back to a little post on the base so you don't have to weave parts of your rifle together. Now, after all that, I suppose I might recommend this to someone bu...
Read More...
Pros:
  • Functional
Cons:
  • price
  • Fit
  • Finish
  • not very well thought out
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you? Yes / No

CR2032 battery holder

by Ed Coker, from United States, AL Written on February 4, 2015
It looked good in the picture, but it is made out of plastic and the tab that locks it to the rail broke off so the battery holder would slide on the rail. Just need to be very careful when installing it....
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you? Yes / No

Spare battery holder for most scope batteries

by Legacy Reviewer, Verified Owner Written on November 23, 2013
Ever have your battery die at the least opportune moment? This holder fits on the picatinny rail and will hold any flat battery that's the size of a CR2032 or smaller(will not fit a CR2430) or slightly bigger than a penny but too small for a nickel. Holder has an O-ring to seal the compartment and a retaining cable to prevent cap loss. It slides easily onto the rail and has a simple locking mechanism that prevents it from falling off but the locking tab is easily lifted for removal. Made of polymer so it should be fairly durable and has a reasonable low profile. Cable length is fixed so it might be too long or too short.
Pros: Lots of pros
Cons: cable length is fixed...
Would recommend: Yes
2 of 2 found the following review helpful.
Was it helpful to you? Yes / No

As desc! Works great

by Legacy Reviewer, from United States, WA Written on July 24, 2012
Great item. Just as desc. Waterproof and easy to install. Mines on a LRT/SASS and fits fine right up against the rec.
Pros: Lanyard,waterproof, fits on rails
Cons: None...
Would recommend: Yes
0 of 0 found the following review helpful.
Was it helpful to you? Yes / No

for those Just In Case moments...

by Legacy Reviewer, Verified Owner from United States, PA Written on June 30, 2012
Does what it is supposed to. Little expensive, but if your battery goes out on your optic and you don't have a spare, well, you get the idea. I cut the tether off, snagged easily.
Pros: lightweight, easy to put on, seals nice & tight
Cons: tether on the cap gets in the way and is easily snagged...
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes / No

Battery holder for a 2032 battery

by Legacy Reviewer, Verified Owner Written on January 3, 2012
Great way to keep a spare battery for an Aimpoint T1 or a Leupold Mark 4 (illuminated reticle model) close at hand. Low profile design with a tethered and 'o-ringed' battery cap.
Pros: Low profile and light weight
Cons: Takes up 1 1/2" of rail space....
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes / No

Vortex Riflescope Battery Holder

by Legacy Reviewer, Verified Owner from United States, WI Written on November 21, 2011
Great item for the price and up to Vortex high standards. I agree with previous reviews on size comments.
Pros: Works well, good craftsmanship.
Cons: None so far...
Would recommend: Yes
1 of 1 found the following review helpful.
Was it helpful to you? Yes / No
Page
Back
Next

Comments on 7 User Reviews of Vortex Riflescope Battery Holder 2032