Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
The Best Lubricant I’ve used... when prepared as an alcohol solution
My ‘go to’ case sizing (and bullet draw down) lubricant is a Lee Resizing Lubricant / 99% Isopropyl Alcohol solution prepared as follows: Mix one 2 oz. tube of Lee Resizing Lubricant in a 32 oz. bottle of 99% Isopropyl Alcohol. Shake the solution vigorously. If the solution has ‘clumps’, warm the mix, then shake it vigorously again. Repeat this process until the clumps dissolve.
Pour the a few ounces of the solution into a pump spray bottle for use as needed.
Before each use, shake the solution vigorously. Dissolve clumps as necessary, as previously described.
Put a quantity of cases (bullets) in a container. Spray and hand tumble the parts for a few seconds (or shake them gently in a sealed container), then spread them on a tray to dry. They should air dry at room temperature in about an hour. To dry them faster, put them in a warm area.
When dry, the cases (bullets) are ready for sizing.
One 32 oz. bottle of the Lee Resizing Lubricant solution will coat thousands of cases or bullets.
The process is very quick and easy... and virtually ‘mess free’.
Happy loading!
Pour the a few ounces of the solution into a pump spray bottle for use as needed.
Before each use, shake the solution vigorously. Dissolve clumps as necessary, as previously described.
Put a quantity of cases (bullets) in a container. Spray and hand tumble the parts for a few seconds (or shake them gently in a sealed container), then spread them on a tray to dry. They should air dry at room temperature in about an hour. To dry them faster, put them in a warm area.
When dry, the cases (bullets) are ready for sizing.
One 32 oz. bottle of the Lee Resizing Lubricant solution will coat thousands of cases or bullets.
The process is very quick and easy... and virtually ‘mess free’.
Happy loading!
Pros:
- Very easy to use!
- No mess!
Cons:
- None
Would recommend: Yes
Very good resizing lube
I have a plethora of resizing lubes on my reloading bench. Hornady One Shot, Dillon Case Lubricant, Imperial Wax, and finally the Lee Resizing Lubricant. The Lee works just as well as others and I have never had a stuck or dented case. I mainly use it for small scale and precision reloading. For Larger scale (reloading 50+ rounds) you would want to use one of the spray lubes to save time. The Lee lubricant is very easy to use, just put a dab on your fingers and rub it on the case and get a little inside the case neck (avoid the outside of the neck), wait a few seconds for it to dry and resize. Best of all it is odorless and not sticky. Itll wipe off quickly with a damp rag because its water soluble and you dont have to worry about the lube inside the neck because it will not degrade powder or primer. Great stuff, I'd recommend it.
Pros: easy to use
Cons: time consuming
Pros: easy to use
Cons: time consuming
Would recommend: Yes
1 of 1 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?