Your Browser is OutdatedLove the 15* angle but not comfortable in bare hand - Strike Industries AR Overmolded Enhanced Pistol Grip
Compare (0)
1 item has been added
Add at least two items to compare
Robert Ellis's Review of Strike Industries AR Overmolded Enhanced Pistol Grip
The rubber overlay is only on the sides and it is not much softer than the polymer. It is definitely rough and grippy wet hands would not be a problem. The front of the grip will give you sore fingers and then calluses after repeated use because there are hard polymer ribs from top to bottom with very squared off edges. I would prefer the front of the grip to be rubber. It is lightweight. Should come with a bolt and lock washer. I had to fish around in my garage to find a longer bolt. The grip thickness at the bolt is 11 mm. There is a .25 mm gap at the trigger guard so it isn’t made with a perfect 90* where it meets the receiver. Just enough to see light come through.
Would Recommend:
Yes