Horrible condition, not load ready - Top Rifle Brass .300 AAC Blackout Reconditioned Rifle Brass

I purchased 500 of these awhile back, load ready as stated by Top Brass.
The condition of the cases were terrible. Huge burrs, inside and outside of the case mouth, almost none of them would fit a Sheridan case gauge. Primer pockets were filthy with a lot of gunk, which I might have overlooked if the case mouths weren't so bad. Trim length had a 7 thousandths differential, but most were 1.358" - 1.362", which is acceptable, though I chose to trim down to 1.358. Primer pockets were swaged\decrimped, thank god because I would have just sent them back if they weren't. A good portion of the cases also had bulges in the body, which could have been from use in a belt fed weapon. Bottom line they required many hours of work to condition into load ready brass, and many went in the trash bin. Now, customer service was responsive, but in my opinion their response was inadequate, they sent me another 250 cases, and all had the same problems. Would I buy from them again? Well, they were cheaper than most other options, and in the end reloading is a hobby for me so I value money over time in that respect, so maybe I'll give them another chance, but if they don't square away their issues with their brass work, IMO selling this as "load ready" brass is misleading at minimum.