Evolution Gun Works Leupold DeltaPoint Pro Sight Mount For Walther PPQ 49394 Red Dot Sights-Footprint: Deltapoint Pro, $4.00 Off

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Modification of your firearm may nullify the manufacturer's warranty.

This product should be installed and checked by a qualified gunsmith.

No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

This Mount Fits:

• Walther PPQ Classic (M1)
• Walther PPQ M2 (All models except optics ready and .22lr)
• Walther PPQ 45
• Walther PPQ 45 SD
• Walther PPQ Sub Compact
• Walther P99 (All Models)
• Walther PPX (All Models)
• Walther Creed
• Walther Creed 10 Round
• Walther PPS (All Models)
• Walther PPS M2 (All Models)

This Mount Does Not Fit:

• Walther PPQ 22
• Walther PPQ Q4 Tac (optics ready)
• Walther Q5 Match (optics ready)

Any Walther model that comes with the standard sights that have the detent will work with this mount. This mount now comes with a set screw allowing it to be used with the friction fit dovetails.

The PPQ sight has a hole drilled in the bottom of the dovetail to accomodate the plunger on some models of the Walthers.

NOTE: For this mount to work with the Holosun 407K and 507K, the rear pins on the mount MUST be removed by milling or filing.

Installation Instructions:

• Remove the rear sight
• Install the EGW Sight Mount in the dovetail
• Tighten set screw (if applicable)
• Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.)
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15in/lbs

Specifications for Evolution Gun Works Leupold DeltaPoint Pro Sight Mount For Walther PPQ:

Features of Evolution Gun Works Leupold DeltaPoint Pro Sight Mount For Walther PPQ:

• Fit Leupold DeltaPoint Pro, JPoint, Shield RMS/RMSc/SMS, Redfield Accelerator, Optima, Holosun 407K/507K (the rear pins on the mount must be removed for the Holosun 407K/507K to sit on the mount)

Package Contents:

• Evolution Gun Works Leupold DeltaPoint Pro Sight Mount For Walther PPQ