Would this fit a Springfield Prodigy — 1 Answer

Not without modifications to your grip module.
Grip Module Interference: The polymer double-stack grip module on the Springfield Armory Prodigy is significantly wider than a standard steel 1911 frame. Users on r/SpringfieldArmory and custom builders note that standard Wilson Combat extended slide releases sit too flush or hit the top edge of the grip module, preventing the pin from seating fully into the frame. [1] (https://www.youtube.com/watch?v=QmtwNroQZWQ), [2] (https://www.reddit.com/r/SpringfieldArmory/comments/175ujyz/prodigy_parts_compatibility/)Required Modifications: To make this part work, you would have to shave off or reshape the tail end of the slide release and sand down the top edge of your Prodigy's polymer grip module to give the extended lever clearance to lift and lower. [1] (https://www.youtube.com/watch?v=QmtwNroQZWQ), [2] (https://www.reddit.com/r/SpringfieldArmory/comments/175ujyz/prodigy_parts_compatibility/), [3] (https://www.reddit.com/r/2011/comments/1kbptdf/slide_stop_compatibility/)