Tap Tap to Zoom
Show with deals only:
Code: 3O4-RE6-RDHNT70-09185
MPN: 9185
UPC: 611760091858
Code: 3O4-RE6-RDHNT70-09163
MPN: 9163
UPC: 611760091636
Code: 3O4-RE6-RDHNT70-09179
MPN: 9179
UPC: 611760091797
Code: 3O4-RE6-RDHNT70-09184
MPN: 9184
UPC: 611760091841
Code: 3O4-RE6-RDHNT70-09183
MPN: 9183
UPC: 611760091834
Code: 3O4-RE6-RDHNT70-09167
MPN: 9167
UPC: 611760091674
Code: 3O4-RE6-RDHNT70-09162
MPN: 9162
UPC: 611760091629
Code: 3O4-RE6-RDHNT70-09166
MPN: 9166
UPC: 611760091667
Code: 3O4-RE6-RDHNT70-09180
MPN: 9180
UPC: 611760091803
The Bullet Seating Micrometer is a highly accurate tool that simplifies bullet seating and aligning. It is marked in inches and in millimeters and can be read with a common metering device or a caliper. With this tool the seating and aligning operation can be done by hand for small pistol or rifle bullets where a high accuracy is not needed. The Micrometer features fine adjustment increments of one thousandth of an inch. Because this tool is so accurate almost any bullet with a standard caliber can be aligned with the seating dies simply by turning slightly on and off the seating dies in the desired increments until the seating dies show the desired bullet seat angle. This tool also features a nut and spacer set so that the spacers can be set anywhere in the seating dies if a close fitting cylinder is not desired.
Manufacturer: | Redding Reloading |
Projectile Caliber: | Universal |
Caliber: | Universal |
Quantity: | 1 |
Bullet Type: | VLD (Very Low Drag) |