I'd avoid this - ATI Outdoors AK-47 Strikeforce Package

This might be the worst piece of equipment I've ever purchased. It's really bad a true 0-star product. It is so bad that the instructions are wrong! This furniture set is a great way to waste your money. Do yourself a favor and buy anything else or just melt your AK down.

First off, the plastic rails are plastic. They will not last. Also with the rails, the included screws are not long enough to mount the rails to the lower handguard. None of them fit because of this. Yes, I know there were two different-length screws included. It was also missing a rail section and the corresponding screws and nuts.

The lower handguard is not molded correctly. Yes, I know, AKs have a tough fit for the lower handguard, however this is not even close to being molded correctly. It is not square at all to fit into the receiver. Even if I were to Dremel it, I would remove so much material that it would not work. I tried softening the handguard to adjust, but that wasn't working either. Whatever they are using to create this piece, it produces an inconsistent product. I've seen videos where it slides right on, but the groove molded into the one I got was impossible.

The stock is a complete piece of junk and the instructions stated to make a 1/16" pilot hole, followed by a 3/16" hole for the screws. Unfortunately, 3/16" is too large for stock AK screws (aren't they metric anyway?). I had to go find new screws that would now fit into the giant holes I drilled into this stock. It wobbles after install, regardless of the screws used. The front handguard is molded incorrectly and the stock is as well. The stock feels like a toy, not at all like something that would stand up to only range use. God forbid if you dropped it.

The saving grace is the pistol grip. This I like. I feels good and went right on without issue.

The issues with this kit just kept adding up to something that is just a really bad product. I am really disappointed in the quality, I thought this looked like a great setup for an AK, but alas, it has way too many QC issues that would cause me concern with any of ATI's products.

I followed this up with a set of Magpul MOEkov furniture and it went right on with zero issues. The tolerances were all within an acceptable margin. Some small taps with the jeweler's hammer is all that was necessary to get everything installed and aligned.