BrianK from United States, ME Public Profile

I have smallish hands and this grip is a bit fat for me. There's no reason it couldn't be made thinner for a better fit. Too, the screws would be easier to start to thread if they were a bit longer. But making the grips a bit thinner would have the same effect as longer screws. There are sharp edges that don't need to be there, in the vicinity of the trigger finger, and again, in that area too the grip could be thinner. But a minute with a Dremel took care of some of those needlessly sharp edges. Making the grip solid in that area would have allowed for fully fitting it (it's hollow under the exterior). I might pour it full of resin so that I can carve away the bits that need to go.

That's the criticism I have and why I didn't give it 5 stars. Once installed they do what they're supposed to do nicely. A true zero degree vertical grip isn't exactly what I wanted, as I discovered after installation. Another grip that I tried allowed only that sort of orientation. My "trick" wrist likes a bit of angle and this grip allows me to have that not quite vertical grip. That's much better, and hugely better than a grip with lots of angle to it when shooting at the bench.

With a little tweaking of the mould by someone who knows what a pistol grip should be would make for a 5 star grip.