Mac5k fitment required - Choate Tool H&K Mp-5 Folding Stock

Installed on a MAC5K. The stock plate pin holes did not line up with the receiver pin holes straight out of the box. The holes on the plate were the same size as the receiver holes but when flush against the receiver were too short and did not line up. I ended up drilling open the holes in the stock plate and filing them to enlarge them slightly in order for the push pins to fit. Stock fits tight, pins require assistance from a punch and hammer to remove for disassembly now because of the tight fit, but at least there is no wobble. There is a very slight wobble from the stock its self from a little play in the extended position, but not noticeable when shouldering. Nothing a little adjusting and fitting couldn’t fix. Overall for the price I’m not complaining and I’m satisfied as it’s a solid stock and gives the OEM look. Depending on the gun you intend to install it on there may be some fitment issues for me the holes were short, but that’s better than too long as opening them up would create a loose wobbly fit with the receiver. Not sure how it’d fit on other clones or the original HK. If you want something that will install straight out of the box with no issues or work I don’t recommend this, I’d suggest getting the HK marked one as the receiver plate from HK has tighter specs for proper fitment. If you don’t mind a little work and have some basic tools and a can do attitude and want to save some money then this is good to go. I cannot speak for fitment with other MP5k clones apart from the MAC5k.