Keep unloaded mad swells. short thin ammo fed 223/62gr. 300vmax. 224 - Hexmag Series 2 AR-15 5.56x45 10 Rounds Rifle Magazine

The nain issue is thr nags getting stuck both 30and 10. My suggestion fir snyone with a 10 before you go and stick it in the lower oil the mag springscand Dremel the very top ewuallybon both sides with a med but. You can use a file or sand oaper with a rubber block but scrapr upwards rught by the triangle st the top aboud anything metal. Then there are these lines on the back side take sand paper to thst and remove a tiny bit of that too be even but be even and careful. Your removing a mm total. If your allowed to remove your mag because you meet the requirements you can use ultra fine paper abd just rill it over the area where the mag locks onto the mag catch ckean it then grease it. Try 29or 9rounds. Use skinnier top bukkets wuch as federal 223 62grain or if youvreally want to hse 300black out use Ammo Inc Vmax no subs. This is a lighter bullet abd thinner qtcthe top rhe heat causes the expabsion and for it to get stuck thing push that button in and rotske it in reverse. If your only using these mags its ok to Dremel the magcatch inner square a tiny bit flat clean and oil. As far as im concerned i do not believe that the mag has to be pinned if its welded into the lower just cant be altered to hold more so you can go to a smith and have them release all your hex mag plates. Then have then replace it with a 3/32set screw. Use loctite glue but the kind that can be soaked in nail polish remover just uncase it happens again or you need to replacecthst spring remember to follow your state laws. If you are handy enough to sand to take down metal make sure you do it in an upwards motion and the tightest point will always be where the bullet crowds the front this is why i said sand down the front area the lines the triangle. These can hold 224* 223/556/300*label your mags. If your hsing 300vmax rounds write 300abd use a color u will only use with that. If your using 556/223dont them together that can cause issues. It wilk throw your group off. You can do 5/5but do not mix it. If your gun is ceracoated then you will probably have issues sand the inner front if the well or the front bullet side if the mag akways clear. And sand that top area ny a triangle. Then you can have them weld your New hex mag mag in. It does not hurt before you do that to get the follower out and just sand around the front and the right and left use any cheap nail filer. Just make sure you grease with hoppes 9gun grease. Clp is goid too but it will drip every where. Your creating more room inside the mag to be able to get iut ibrcday or to orevent crowding jams to fit. Get them to replace that plate back on in compliance to your state only reason cto have renived was to shave the follower