Neck turn tool hornady #041224 - Hornady Lock-N-Load Neck Turn Tool

I got the part in relatively decent time but the neck turning part number 3. The silver part starts wiggling like its outer round in the beginning but then I find out the backpark number 5 the shell holder spindle if we don't. Have your shell in perfectly?
I'm lined it up in the neck turning body.
It will wobble like it's out around so I got that down finally. You have to really put in New York casing really straight in the spindle so to keep it from wobbling but the problem is the shell holder spindle. Goes through a piece of casting the is not very straight and the whole thing has a wobble to it so it's not very precise if they would have. Put a bearing in each end so you would slide through into a perfect bearing fit. It wouldn't rock.
So I don't know how precise this is going to be when I go ahead and really shoot.
It might work out OK but it might be awful half a 1000 2000s trying to make it round. It's not like putting it in a lave if they would put a bearing in the shell holders spindle side.
It would be a much better tool.