Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
MassSucksAzz's Review of HYVE Technologies CA Edition Glock 19 Magazine Base Pad
Here’s my experience so far…
The installation was easy.
Because Glock magazine got side notches, i used a tiny mallet and just hammered it in until the mag was flush.
Before tightening the screw, I Loaded the mag to check for spring tension and cycled a few rounds before causing a double feed several times.
I Took the base off and noticed i had failed to put the inner plate from my stock Glock mag, in with the new base (it came with no instructions tbh Idk if you’re supposed to install it with it or not) BUT after I put that inner plate with the HYVE base I’ve had zero double feeds.
It’s just 3 items, the Aluminum Base, an Allen Wrench and the Screw. (Screw is not loctite) no instructions.
It’s aluminum, and you will feel a slight weight to it but it’s fine for me.
I got big hands so it feels great in my hand and it looks good.
On to the range…
The installation was easy.
Because Glock magazine got side notches, i used a tiny mallet and just hammered it in until the mag was flush.
Before tightening the screw, I Loaded the mag to check for spring tension and cycled a few rounds before causing a double feed several times.
I Took the base off and noticed i had failed to put the inner plate from my stock Glock mag, in with the new base (it came with no instructions tbh Idk if you’re supposed to install it with it or not) BUT after I put that inner plate with the HYVE base I’ve had zero double feeds.
It’s just 3 items, the Aluminum Base, an Allen Wrench and the Screw. (Screw is not loctite) no instructions.
It’s aluminum, and you will feel a slight weight to it but it’s fine for me.
I got big hands so it feels great in my hand and it looks good.
On to the range…
Would Recommend:
Yes