Front pivot pin not machined properly - KAK LR-308 Lower Parts Kit

I didn’t have any problems with this other than the fact that the front pivot pin is not machine properly. It is supposed to be flattened where it would otherwise interfere with the receiver towards the rear of the pin as it inserts, otherwise it won’t allow insert entirely. However, if you take off flat grinding wheel on a Dremel and you can flatten That pivot pin until it seats properly, which is probably easier than ordering a separate pivot pin set unless you happen to be reading this before you purchase this kit. I won’t comment on the trigger components because I think most people reading this who are building their own set ups will probably have their own triggers anyway and will either put these in the parts drawer or throw them out entirely in the trash.