Utg low profile mount - UTG MP5 Bidirectional Low Profile Clamp Mount

This is the third utg HK mount I have purchased. The first two were put on cetmes. This was put on a C93. This had to have about 1 inch removed to fit the shorter receiver. I put a strip of outdoor double sided tape between the receiver and the mount to provide more stability. I found if you loosen the four screws, place the mount in position, and use a spring clamp, or c clamp to hold the cleets in place as you tighten the screws it will make this project move alot smoother. Once in place no need to remove.
Pros: Inexpensive
Cons: none

This review was written in the old system and had content requirements that are different than reviews written today.