A little bit of a pain to get adjusted correctly, be patient it is worth the work - Lone Wolf Arms Ultimate Adjustable Glock 9mm/.40 S&W/.357 SIG Trigger w/Trigger Bar

installed this in my glock g40 10mm long slide mos, used this trigger with the ghost pro with the trim to fit back stop, dont use this combo, use the standard ghost pro, the stop adjustment in the trigger is not compatible i ended up filing the connector back stop completely off, adjust the trigger in 1 quarter turns, will take time to get it right and many disassembly/assembly however it is def worth it, i get 2.7 pound average out of ten dry fires, i used the 6 pound trigger spring and the 4 pound striker spring with the maritime spring cups, polished all the contact point to 33k by hand, no dremel or so called 25 cent trigger job as that takes too much metal off and removes the coating on the trigger bar this will be a dedicated hunting rig so the light pull is exactly what i was looking for, the trigger feels close to my 1911s although this is def a glock, i wouldnt recommend this for carry use as it is a very light pull.... i also installed the 6.6 inch lone wolf threaded barrel and with the cci 180 fmj flat nose, it is super accurate out to 50 yards so far, factory sight are not the greatest and awaiting the red dot, im sure this firearms will in fact be a tack driver when completely finished...i would def buy this trigger again for target or hunting but NOT for carry, in my opinion it has too light of a pull, your mileage may vary with a different setup though...good luck