Defective set screw design - ODIN Works ATLAS Compensator

I think this is an innovative design in that timeing it requires no washers and makes installation easy , but where assembly of this compensater goes wrong is in the set screws , if you watch odin works video on installation they tell you to only lightly and i mean lightly snug these set screws down no more than one quarter to one eighth a turn so here we go , set screw one , one quarter turn after contacting the surface ok , set screw two the same , no problem , set screw three goes clean through into the baffle theres no tightening this one . Honestly , after tightening the end cap you may not even need the screws but there's a lot of violent flexing and vibrating and pressure going on after a shot so i dont trust it therefore i never fired it and sent it back . In the future if this flaw is corrected i will purchase this compensater gladly and look fwd to putting it to use .