Your Browser is OutdatedDoes not fit in midwest industries hand gaurd - ODIN Works Clamp-On Adjustable Low Profile Gas Block
Compare (0)
1 item has been added
Add at least two items to compare
Ted's Review of ODIN Works Clamp-On Adjustable Low Profile Gas Block
The squared off portion of the gas block on the side of the top sticks out too far and gets cuaght in the m-lock cut outs. If you have an anti rotation handguard this likely wont work as you will not be able to wiggle the hand guard around the protrusion to get it in place. Pretty disappointed. Parts are hard to come by right now and a low profile gas block should be able to fit in any reputable hand guard.
Pros:
- Dont know it's expensive and was not compatible with my setup
Cons:
- Not compatible with all handgaurds
Best Used for:
- Good question
Would Recommend:
No
5 of 5
found the following review helpful.