Odin works 6.5 grendel complete kit - ODIN Works Grendel/LBC Barrel, int gas placement, w/tunable GB, Stainless Steel

Item arrived as described; have not taken out to test yet; review is for install and finish comments - there are two options through Optics Planet; one with the barrel and gas block, the other with the 6.5 Grendel BCG, barrel, gas block, and in the case of the 18” barrel set, it comes with a stainless gas tube. This review is for the latter. All parts included: just seat barrel in the upper receiver, connect the gas tube/block, add a handguard, slide in the new BCG. Finish was great—barrel appears flawless-packaging indicates sub-MOA guarantee; some machining marks on the outer side of the tunable gas block, but nothing that should impede operational performance (and it’s not seen anyways after covered by handguard). Roll pin is included to attach the gas tube; an extra set of hands is helpful to keep the tube in place while taping in the pin with a punch before tightening down the gas block. The barrel is marked to align the gas block, which is nice to make sure everything goes on straight. Finished with an Odin Works O2 15” handguard and Odin works thread protector. Appearance of set up looks great in my opinion. As a side note on the O2 handguard, the black finish is a bit darker than the Vltor MUR upper it connected to-not an issue for me, but if looking to have exact match, know that it may vary depending on your upper.