Solid but needed trimmed - ProMag AAS111SLA Archangel Precision Elite Stock Black Synthetic Savage 11/111

This was installed on a savage 110 long action with the ball release on the side and not on the trigger guard. There was an internal piece that could be removed to accommodate for the side release. I had to dremel down some of the interior underneath of the removable piece to create enough clearance for the receiver to seat properly as well as sufficient space for movement of the action. I also trimmed a little bit off of the front of the cheek rest. Where I needed it adjusted to for a proper height to the scope, aligned it with the bolt. Not allowing the bolt to fully come to the rear by approximately an eighth to a quarter inch. These modifications were not overly difficult but at the same time had to be made for proper fitment.That said, I like the stock. It gives me the adjustments I was looking for and doesn't break the bank at the same time. I only wish that the front forearm would be angled instead of flat for minor adjustments.