Update to my previous review - OpticsPlanet Exclusive RISE Armament RA-434 High Performance Trigger

This is to update my previous review. I was consistently getting an 8lbs trigger pull from the middle of the trigger, 7lbs from the lower 1/4 of the trigger, and 6lbs from the bottom edge of the trigger. Tried playing with set screws, swapping my KNS anti walk pins for normal trigger pins, pull weights stayed the same. Also i had a lot of difficulty getting both trigger pins into the receiver. Put my Timney in the Aero M5 lower and pins slid right in. This, coupled with the other issues I had, Rise Armament had me send the trigger back to them to inspect and repair or replace. They replaced the whole unit and sent me a new one. The bottom of this one was a little bit sharp that I needed to polish. But, this is a very good trigger. Crisp 2.5lbs break when pulling from the lower 1/4, short reset, no grit at all on pull or reset, both trigger pins slid in and out easily.