Bore was too small on almost every caliber. do not purchase!! - Strike Industries Carbon Fiber Suppressor Alignment Rods

This review is for the strike industries suppressor alignment rods. I've used rods in the past by other vendors which actually worked well. They sat in the bore snugly. These rods slide freely in the bores. In fact, every single one showed that the suppressor was out of alignment, when that was not the case when used with rods that fit the bore the barrel appropriately. I tested 22 6.5, 9 mm and 45. Each one of them were too small for the boar and slid right through. Did not snug did not hold each. One of them showed they were out of alignment. I do not recommend this product. I tried contacting opticsplanet to see if I could do an exchange. Maybe it was a single unit having this problem ... Though not likely because multiple rods did not fit multiple bores, but wasn't successful even waiting on hold for over an hour and a half. I was just hung up on by the IVR or automated system. I also had trouble contacting Strike Industries as well. I've purchased from strike before and they do have some great products, but I do not recommend this at all