Wrong roll pin, hole too small. it ain't a badger, that's for sure!! - Trinity Force Extended Charging Handle Latch

This charging handle arrived to me with two problems: One obvious, the other, not so much.

The obvious problem was that the included roll pin is about 1/2 the required diameter. No problem, I thought. I'll just use the old one!

When attempting to install the latch, I couldn't understand why the roll pin wasn't setting. Thinking I had misaligned the latch, I continued attempting to realign the latch with the charging handle holes, and drive the pin.

Finally, I disassembled the entire thing, and observed that the hole drilled in the latch was too small!!! (Despite being too small, it was still larger than the hair-thin roll pin!!).

Once I enlarged the hole in the latch with a drill, upsizing it to match the roll pin, the installation was relatively
straightforward. I suppose I should take consolation from the fact that it was 1/3 the price of a Badger.

I wouldn't order another one, nor would I recommend it.