Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Judge Joe Brown's Review of Trinity Nevada Ground Breaker Complete Slide
The difficulties described with the nose of the round hitting the top of the barrel hood & jamming most probably is due to interference caused by the red-dot/cover-plate mounting screws—particularly on the right side of the slide—& the extractor/spring assembly
The likely problem is that they’re too long
It is unclear whether an RMR footprint red dot was mounted (or just the cover plate) … but insomuch as the slide cut is low—& does not require an adaptor plate—there is a likelyhood that there is screw interference
Try backing the right hand screw off until it is just about out & you may find the feeding issues go away
You can ✓ this by attempting to chamber a round
If it clears up, secure a shorter screw … you probably will find one particularly short with new sights for use in Glocks
This is ALSO an issue with Sigs … use a Glock length screw on the right … or cut one down to a length that won’t bind the extractor set-up
The likely problem is that they’re too long
It is unclear whether an RMR footprint red dot was mounted (or just the cover plate) … but insomuch as the slide cut is low—& does not require an adaptor plate—there is a likelyhood that there is screw interference
Try backing the right hand screw off until it is just about out & you may find the feeding issues go away
You can ✓ this by attempting to chamber a round
If it clears up, secure a shorter screw … you probably will find one particularly short with new sights for use in Glocks
This is ALSO an issue with Sigs … use a Glock length screw on the right … or cut one down to a length that won’t bind the extractor set-up
Would Recommend:
Yes
3 of 4
found the following review helpful.