Reviews & Ratings for Warne 1in Permanently Attached CZ 550 19mm dovetail Medium Rifle Scope Rings — 5 reviews — Page 1

I have a CZ 550 308. It's a hard to find 20" barrel 308 and it kicks like a mule as a result. These rings haven't budged. They're holding onto a Leupold VX-3 2.5-8x36 scope which, if I'm honest, I'd like a little lower/closer to the barrel, but it's at a good height and the same height as any more "normal" 40 or 40mm objective scope would be in these rings anyway. I would say these rings seem a little heavy, but they are the best rings I could find for my CZ rifle by far. I bought them all, returned all but these. The design makes cinching them down while keeping the scope level a pain in the royal behind, but once you get it, you get it. Just make very sure you get your eye relief set up to your liking. I had second thoughts and had to do the process all over again. I think, also, that these rings look really nice. They look lean and aren't an eyesore distraction on the top of my classic rifle.

I got these for a CZ550FS rifle. These rings will fit a 19mm dove tail mount and hold a 1" scope tube. Had the scope and rings installed in 5min or less. Rings are good quality and sturdy. Scope holds zero. This fit my specific need, which was not the typical scope mount setup.

As always, Warne are the best! Can beat these strong steel rings. Great fit on my CZ550. Used the medium height to mount a Zeiss Conquest 4.5x14x44. Just enough clearance for the bolt and it got my scope closer to the barrel than the factory rings.

Delivered fast and as described. Recommended by the CZ rep for use with my Leupold scope. They hold tight and are easy to mount. I would highly recommend them for your ring requirement. Best quality rings for the money!