Tap Tap to Zoom
Show with deals only:
Buy Together and Save
Their red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.![]()
Simply remove the rear sight on your gun and replace it with one of these Red Dot Sight Mounts in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions: Remove the rear sight. Install the Evolution Gun Works Sight Mount in the dovetail. Tighten set screw (if applicable). Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws. Torque mounting screws to 15in/lbs.
2 Button Head Cap Screws Provided for Vortex Viper and Venom Sights. 2 Flat Head Cap Screws Provided for Burris FastFire and Docter Sights. The screws that are included with this mount require a 5/64in allen wrench for installation.
Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Please note: We have found that some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. These dots may not fit properly on the posts on the plate. We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins.
Mount with MPN:49297 fits Desert Eagle Post 2017. Mount with MPN:49303 fits Desert Eagle Pre 2017.
| Manufacturer: | Evolution Gun Works |
| Color: | Matte Black |
| Finish: | Hard Coat Anodize |
| Fabric/Material: | 7075 Aluminum |
| Optic Cut: | Docter/Noblex, Vortex Viper, Vortex Venom, Burris Fastfire |
| Length: | 1.811 in |
| Width: | 0.99 in |
| Included Accessories: | 2 6-32 Flat Head Screws |
| Mount Type: | Dovetail |