Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Great color and fit, fast shipping.
These rings were for a new Burris Eliminator 6. While initially leveling the sight (bottom base halves of the rings screwed down on the rifle with the scope resting on them) both the scope and the bottom bases were very tight and could barely pivot the scope. Was so tight it ended up scratching the scopes finish so be careful.
Would recommend: Yes
Xbolt Owner
Bought 2 sets (34mm high and 30 mm med about a year ago, just tried to install yesterday (Back Surgery)using my Wheeler Fat Wrench set on 18 in pounds! One screw twisted off in the base and 2 screws stripped out in the rings! Now I have a brand new H Canyon Long Range with a base screw sheared off in my rifle! Not even going to try the 30 mm on it! I’m out of about $180 for the both and gotta find a gunsmith to tap out the broken screw! Expected better!!!
Pros:
- Color matched
Cons:
- Very poor quality!
Best Used for:
- A reason to find a Gunsmith!
Would recommend: No
Not Good Not Good at all
Will not mount the scope level, would never buy again! Although I didn’t not have any issues with the threads stripping out, I would not but again! The color is a perfect match to the Browning Canyon cannot put the full name in because it’s not “family friendly”! That is the only positive I can say about it!!
Would recommend: No
Difficult to install evenly and threads strip.
It marked up my new Leupold scope, too tight of a fit. The rings wouldn't close down evenly and was almost impossible to not have a big gap on one side. One of the holes stripped with 18 inch pounds. Very frustrating.
Pros:
- Nice matching color to my X-Bolt
Cons:
- Fitment and threads stripping.
Would recommend: No
There are no reviews that match your criteria. Would you like to review this product?