Downsouth from United States, FL Public Profile

This handguard will fit the century c308 rifle with some minor fitting, it requires the removal of a small amount of material in the front so it will allow it to fit around the front sight mount. Then drill and tap 1 10/32 screw 1 1/16 inches from the rear of the handguard at the same elevation as the front screw this will allow the screw to go in between the barrel and the cocking tube and when tightened it will cause the semicircular shape on the rear of the handguard to squeeze into the semicircular section on the front of the receiver when tightened it's cinches down rock solid on to the gun very tight, have done this with three cetme rifles so far and have had no problem a little bit of measuring and minor Gunsmithing anybody can do at their work bench. The people who reviewed this handguard and said it will not work at all should not own the rifle if they cannot figure out how to adapt the part to the equipment

Necessary part for the 5x primary arms acss scope, exact fit for the factory base, be sure to warm the factory screws a little with a heat gun when taking them off. High quality part have them on all my EQ thanks opticsplanet great price