GLKCOMA from United States, GU Public Profile

Upon initial inspection the item seems to be of a good quality. It's a little smaller than I expected as I've never used or seen a Caldwell brass catcher before. Definitely gonna us this product during range days to keep the range clean and collect my brass for reloading or recycling.

Just a heads up, if you purchase this item then there's a step or two you might wanna take before using the Oppressor.

I recommend using blue loctite on the small screws located on the mounting portion of the Oppressor. MAKE SURE TO APPLY LOCTITE ONE SCREW AT A TIME.

After the first use and 180 rounds later (60 round mag dump with a binary trigger) I noticed that the Oppressor was difficult to remove. Upon inspection I see that one of the screws had come out which made it difficult to remove the Oppressor. A small hex key wrench in the hole and a little adjustment made it much easier to remove and install.

I reached out to Strike Industries direct and was advised that this was an issue on the earlier batches. I requested from SI if they could send me just the screw and that I'd fix it myself, they ended up sending me a whole new Oppressor at no charge. Great customer service if you ask me. Now I have two Oppressors.

This rangefinder serves me very well. I've used it many times to get accurate measurements for target practice and to gauge my bearings. It's measured up to 1083 yards though I couldn't verify the actual measurement through other means. Great quality product for an awesome value.

This binoculars are a great quality set of binoculars for a phenomenally affordable price point. The lens is virtually crystal clear and images are crisp even out to 400 yards. The adjustability of the binoculars is amazing.

Purchased this to add to the tool set I'm slowly building up and upon first use it worked flawlessly. It provides a sturdy and steady hold that holds the barrel steadily. I'm not sure what more great things I can say about this product.

Installed this product on my Mossberg 500 equipped with a BlackAces quadrail and it fit almost perfectly. I say almost because the handguard barely touches the quadrail but not enough to inhibit its function. It's got a great feel to it as it fits perfectly in either hand and adds better grip than the previous forend that was installed which was a Hogue rubberized forend.

Highly recommended.

Installed this trigger guard on AP lower and it fit perfectly fine, no issues whatsoever. Put a little bit of blue thread locker just to be certain the screws don't back out.

A minor issue I had was that this trigger guard does not work well with the Magpul 60 round drum mag. There's a part on the trigger guard that will interfere with the drum mag and cause difficulty when putting the drum mag into the mag we'll or releasing it. This issue will make it difficult for the drum mag to engage the mag catch and will require a bit of force. Releasing the drum mag is just as difficult.

Solution: file down the part of the drum mag that hits the trigger guard. I filed my drum mag and it engages and disengages with not issues at all.

Pins are great but everything else needs a little work.

It doesn't come with detent springs so you'll have to get a set if you don't already have some. The springs are long enough that they provide too much pressure to easily engage and disengage the pins. Springs will have to be cut a bit shorter for the pins to properly work.

Install of the pins is really easy and removal is just as easy.

Installed this grip on my AR pistol and it fits great. The ergonomic design make this grip a pleasure to shoot with compared to the Magpul MOE grip that came with my pistol. I'd definitely recommend it.

Recently installed this ambi safety and it added both function and style to my pistol. Install was easy and the option for the 45/90 is great. I would definitely recommend this safety for your gun.....