Pharm from United States, VA Public Profile

Not only does this grip have a great contour for any size hand, but the finger grooves are exceptional for gripping. Furthermore, it has a a bit of an underside to it that snugs up well to the trigger guard. Due to the shape of this grip, I have found it to be the absolute most comfortable grip to mag swap while still keeping the rifle shouldered. Gone are the days of developing blisters on the inside of the ring finger. I have this grip on all of my ARs and have spares around just incase I pick up some more rifles. It is a bit oversized, so if you want an absolutely perfect flush fit, you might want to take a dremmel to the inside of it, however that is not required at all. It comes with a decent capacity slot inside the handle for some extra red dot batteries or whatever else you choose. Hard to beat this price, nearly impossible to beat this grip, certainly impossible to beat it for its comfortable shouldered reloads. One thing to take into consideration is that if you have a full sized ambi safety, you will run into issues on the right side of the grip, as it is not carved out to fit one. However it will fit an ambi with a shorter lever on the right side of the gun. I cant emphasize enough how unbeatable this grip is. I frown upon all other grips. Your hand is how you interface with your rifle, and your finger with the trigger. Get a good grip and a good trigger, that's my opinion.

Very comfortable to grip underhand, or overhand with a very close grip that is surprisingly comfortable. Definitely noticeable how much lighter and nimble it is compared to a full 16 inch. The lack of a forward assist is very pleasing. The only reason I am giving this 5 star item 4 stars, is because the fine print says that its a .250 outer diameter for the takedown pins. I had quite a fair bit of slop with this aero upper on my aero lower. So keep that in mind when building with this upper. I had to go back and buy an aero LPK, and while the front pivot pin was much tighter and offered very little play, the rear takedown pin still rattled around inside the hole of the upper receiver. I tested it and didn't even bother taking the buffer tube as a result. I ended up using a .003 shim that I found on a website and put it on the front pivot pin, and also used a accuwedge. Maybe I just got a poor fit and its not indicative of aeros typical product, nevertheless I am very pleased with the upper, even given the extra expenditure and frustration. Keep in mind, it is hard to find .250 OD takedown pins. If I could actually find anything in stock, I would have bought some double oversized pins and sanded it for a perfect hand fit. Hands down this is the best handguard at a minimum that I have seen on the market. Good luck in your purchases.