Reviews & Ratings for Ed Brown Products Pistol Magazine, .45 ACP, 8-Round — 8 reviews — Page 1

Good fit and feeding in RI 1911. If you want to use HP ammo this is the mag.

Great part to get a RI 1911 to feed hollow points.

I have used several brands of 1911 mag's,The Ed Brown are up there with Chip Mccormick but $20.00 Less per mag.

I have spent a lot of money on 1911 magazines in the past years,Just to get a magazine that can run fast with jaming.I have a Hand full of S&W ,Magpul And some high end brands.But the Ed Brown are the the best For Springfield,Kimber, And even off shore made 1911's .

I received my 2 Ed Brown .45 ACP 1911 8 round stainless-steel magazines undamaged and in a timely manner. The one mag. fit perfectly into my new Springfield Armory Milspec .45 ACP 1911 (5") and snapped easily into place with just a push. The other mag., however, required a hard smack on the butt pad to seat and lock it into the gun. I removed the plastic bottom and let the secondary metal cover under it hold the spring in place and it snapped perfectly into the gun. A bit of light sanding (maybe .005" to .010") of the top of the plastic cover where it hits the mag-well slightly would take care of this small issue of "tightness". The magazine depicted shows numbers adjacent to the bullet sight holes, however, there were no numbers on the mags. I received. I would still buy these again as they are well rated and high quality built. The metal follower is also nice, and more period correct if you care about that. I would recommend these magazines.

I ordered 3 of these for a new 1911 I just purchased. I might be able to afford an Ed Brown 1911 some day. But these magazines are not expensive, especially if you get the unpainted version. They are very high quality. They operate smoothly and fit perfectly.