Your Browser is OutdatedGood looks, little difficult to install - Strike Industries M4 AR15 Fang Series Trigger Guard
Compare (0)
1 item has been added
Add at least two items to compare
Polux's Review of Strike Industries M4 AR15 Fang Series Trigger Guard
The guard does it's job (it's just a trigger guard) and looks different, not sure if the little ramp helps that much for magazine insertion, maybe under strenuous circumstances or speed reloading? but looks cool. The side where the threaded pin goes is hard to install (unlike other similar construction trigger guards) as the fit is very tight and the pin just spins until you press very hard and then starts threading. recommend to thread off the receiver, unfortunately for me I had already pressed in the roll pin on the other end.
Pros:
- looks different
Cons:
- installation
Best Used for:
- customize
Would Recommend:
Yes
1 of 1
found the following review helpful.