Your Browser is Outdated
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
Rock solid rail
Another quality product from Troy. Installed on Colt M4 without issue. Easy to install with a great lock up system. Creates a solid platform for adding accessories to the rifle. Quick shipping and a great price from Optics Planet.
Most Helpful Negative Review
Troy Quad rail
I tried this rail on three different uppers with the same results it would not index flat, it also sat to high compared to the upper. This just became an expensive pile of aluminum. Optics Planet did a great job with shipping so no fault with them, it's Troy's poor quality control.
M&P 15 Sport Perfect fit and solid
I am super happy with how perfectly the top picatinny lines up with the rail on the receiver. It feels like it was built perfectly for the S&W m&p 15 sport. I also have the sport 2 so I’ll be getting a second. The Troy hand guard is also solid and the qd mount worked perfectly with my magpul ms4 sling. It’s very high quality. The address lettering is a little brighter on the m&p 15, where the address lettering on the Troy rail is more of a gold cream, but that matches the laser etched m&p logo on the side, so it’s all good. I suppose it’s also a little more tactical with the more dull color rather than bright white. Very satisfied
Pros:
- solid construction
- fitment
- color match
- High quality feel
- no twist movement
Cons:
- None
Would recommend: Yes
Very loose fit
I installed the Troy battle rail on my M4 after reading positive reviews but to my disappointment it was short by about 1/8 of an inch front to back and had 1/4 in side to side wiggle which made mounting a rail mount laser a complete waste of time.
Would recommend: No
1 of 1 found the following review helpful.
Troy drop-in quad rail
Under two minute installation, fit and finish were great. Matte finish, not shiny. Extremely solid in the hands. Perfect for anyone staying away from the cheap Chineseium out there. If you’re looking for a GWOT inspired build, this is your ticket. The only negative was the mounting screws. I wasn’t sure if there were some specific coating on them or the early onset of corrosion. Worst case spend $.50 on new screws. Great value in my opinion I’ll be buying again.
Would recommend: Yes
SOLID and High Quality
This was not the easiest thing I've ever changed on my rifle - I got the tool to compress the Delta ring but it still took me 15 minutes of wiggling for it to seat properly. BUT, once it is on correctly, it is very solid and will not move. I love it. I had the original Magpul handguard on a Colt 6920 forever, keeping me from mounting top rail ir/laser gear, and now I have the rifle I've always wanted it to be. Highly recommend the Troy handguard. I got the enhanced version which means the top rail extends to the receiver, giving the illusion of a monolithic rail.
Pros:
- Lightweight
- Fits well
- Solid as a rock
Cons:
- None
Best Used for:
- mil spec M4, Colt M4 6920
- replace Magpul handguard
Would recommend: Yes
perfect fit to replace plastic hand guard
Placed this on my M&P Sport 2
Fit in perfectly and is supported by 4 screws to further secure it. The product is pretty is very sturdy, it’s just a little rough on the hands.
This is the enhanced version to the rail create a better flush fit on the top. Very niice
Fit in perfectly and is supported by 4 screws to further secure it. The product is pretty is very sturdy, it’s just a little rough on the hands.
This is the enhanced version to the rail create a better flush fit on the top. Very niice
Would recommend: Yes
Solid, doesn’t budge
I got this for my M&P 15 Sport II and it fits perfectly. Super easy to install, and I didn’t need any tools or anything like that besides a flathead for the screws. Before this I bought a Magpul hand guard, and didn’t like the way that it would move back and forth a bit (toward and away from the delta ring assembly) without too much effort. Made the whole set up feel cheap and unsecured in my opinion. This rail is rock solid and doesn’t budge. The QD mounts are convenient too. Very happy with this purchase!
Pros:
- well built
- EASY INSTALL
Cons:
- None
Would recommend: Yes
7 of 7 found the following review helpful.
Troy battlerail
Like all of Troy’s products this thing fits like a glove. Came together in a snap and is well detailed. A drunk chimpanzee could slap this i
On your rifle in less time than it takes to duck the poo he would sling at you. The rails are sharp and clean and could probably double as a mace if you can afford extra ammo. Have no fear about this piece fro Troy.
On your rifle in less time than it takes to duck the poo he would sling at you. The rails are sharp and clean and could probably double as a mace if you can afford extra ammo. Have no fear about this piece fro Troy.
Would recommend: Yes
2 of 2 found the following review helpful.
Well made and America
On a Colt CR692:
Just received. Overall good looking rail. Fits like a glove. I recommend highly.
The fit is very tight. You’ll appreciate it once installed. You have to seed the rail in with some pressure. Don’t rush install, do it methodically. personally this rail isn’t coming off, so I used red loctiite. Don’t screw in with a lot of pressure just until first tight; don’t ruin the thread from over tightening.
Added two 6” Troy hand guard - bottom and left.
Added one 4” Troy hand guard on the right side and mounted surefire with pressure plate on top rail.
I would buy again. Shipping took a week.
Just received. Overall good looking rail. Fits like a glove. I recommend highly.
The fit is very tight. You’ll appreciate it once installed. You have to seed the rail in with some pressure. Don’t rush install, do it methodically. personally this rail isn’t coming off, so I used red loctiite. Don’t screw in with a lot of pressure just until first tight; don’t ruin the thread from over tightening.
Added two 6” Troy hand guard - bottom and left.
Added one 4” Troy hand guard on the right side and mounted surefire with pressure plate on top rail.
I would buy again. Shipping took a week.
Pros:
- Nice finish
- American made
- Mil-Spec Quality and fit
Cons:
- non yet
Best Used for:
- Support American Made
Would recommend: Yes
1 of 1 found the following review helpful.
Great fit for S&W
Just recently got a S&W sport2 and the 1st thing I wanted to change was the look of it and be able to add on to it. This definitely did the job. Looks great! And was able to add my front grip and light with no problems. Highly recommend
Would recommend: Yes
3 of 3 found the following review helpful.
There are no reviews that match your criteria. Would you like to review this product?