AmeriGlo Smith Wesson Night Sight Sets, Green, M&P Shield
As Low As
$71.79
Save Up to 22%
View Product
Compare (0)
1 item has been added
Add at least two items to compare
Most Helpful Positive Review
AmeriGlo Tritium Front and Rear Sights MP Shield 3 Dot night Sight set GRN,GRN SW-145
Be aware that the MGW sight tool for M&P will not work on the shield. The Meprolight KimPro Universal Sight Tool or other will be best. I've installed night sights on quite a few of my pistols that came stock with contrast or painted dot sights and the Ameriglo SW-145 tritium 3 Dot night sight set i...
Read More...
Read More...
Most Helpful Negative Review
AmeriGlo 3 Dot for Shield
Not really bright enough to make a big difference, so I can't say they're much of an upgrade over the factory sights. I was dissapointed in what I got for what I paid. I knew they would be difficult to install, but I was prepared for that via YouTube, so that went as smoothly as could be expected.
C...
Read More...
Read More...
They fit the Performance Center model
A "gear expert" in the question section said they wouldn't fit. They fit fine but are dimmer than I'd like. A drop of Kroil overnight helped. Install required rubbing the front on sand paper. I like that there is more light around the front. 147 grain seems to hit a poa just like the factory ones did.
Would recommend: Yes
2 of 2 found the following review helpful.
Lamp are dead
As the title says the lamps were dead in 4 years. If I had to do it again and I probably will I would spend more money on better night sights. I’ve had good luck with Trijocon in the past. In the past the trijocon lasted around 10 years.
Pros:
- Cheap
Cons:
- Cheap
Best Used for:
- Range
Would recommend: No
Amazing upgrade
These sights are a great upgrade over stock they are easy to pick up in low light the factory rear sight will be very stiff coming out but the difference is amazing I would definitely be putting these on more of my pistols
Pros:
- Great sight
- Great site acquisition
Cons:
- Factory site hard to remove
Would recommend: Yes
Shield 2.0
Got these for my S&W Shield 2.0 after seeing the reviews. Big upgrade, well seen in the dark. I doubt you'll be dissapointed if you decide to replace the factory sights. Only downside is getting the factory rear sight out, its pretty tough. Get yourself a good nylon punch while your at it.
Would recommend: Yes
Says for shield models... kinda..
Rear sight is bigger than the factory shield sight and will hang over the back of the slide a little bit. The rear sight, the tritium crystal isn't even centered under the opening correctly. Buy a better brand. Not recommended. I don't need that rear sight snagging things coming out of holster. Sucks i had to spend all that money only to get a front sight. Fortunately the front is the exact same height and width as the factory one. Personally i don't like the lighted rear anyway, draws your eyes off the target at night. Another issue with this on a shield model is the distance between the sights. The aperture on the rear is too wide for the shorter distance and there's a lot of fudge room, combine that with the dot not being centered and you'll have a hard time hitting your mark. Junk.
Pros:
- None
Cons:
- Poor design and description
Best Used for:
- Collecting Dust
Would recommend: No
AmeriGlo Night Sights for Smith & Wesson . . .
Heard these were great sights and priced very good. However, I had doubts about using the sights being that most sight are 3 dot. Turns out that I like these sights very much as they make sight acquisition quite easy as opposed to a 3 dot system. They were a great addition to my S&W Shield 9mm.
Pros:
- easy acquisition
- great at night or low light scenarios
Cons:
- None
Best Used for:
- night or low light
Would recommend: Yes
Ameriglo I dot
Have a ameriglo set without idol and it’s ok but these on a mp shield are money. Get a plastic or brass punch for install. They were tight but do able w punch and hammer. Finish is nice and tritium is bright
Would recommend: Yes
Fits great , shoots straight
Was easy to install with a brass punch just make sure to loosen set screw on ones you remove. Works great in low light conditions as well as in daylight. I am very pleased with my purchase. Is just as good as more expensive ones. I honestly think they are brighter than the ones on my new Sig Scorpion 1911 Carry
Pros:
- Easy to install
Cons:
- I had no cons
Best Used for:
- Night use or low light
Would recommend: Yes
Ameriglo night sights for M&p shield
Very nice sights. Super bright. Easy to install. Red front sight super easy to pick up in daylight. Delivery was fast and packaged securely. I like them as well or perhaps better than the trujicoms that I have on my Sig. will definitely be putting them on my Newest Glock 30z
Would recommend: Yes
AmeriGlo night sights for M&P Shield
These sights are bright and easy use in the dark. They also create a good sight picture during the day, though they do not glow.. I've put about 150 rounds through my Shield since getting them. I would recommend these to a friend.
Pros:
- Good sight picture regardless of light conditions
Cons:
- None
Would recommend: Yes
There are no reviews that match your criteria. Would you like to review this product?