You upgraded your glass, now you can't run your bolt! - Anarchy Outdoors Clamp-On Bolt Knob for Remington 700

I have been making do with used gun show/handed down scopes for years, and I recently decided it was time to upgrade them to modern scopes with nicer glass and modern features. This presented a problem, as I didn't want to replace all of the mounting systems that had proven reliable. When I replaced the old scope on my Remington model 7, it had 1 in, low rings, but modern scopes these days come with really large ocular bells. The bolt handle will clear the side of the bell and the adjustment ring, but it doesn't extend past far enough to allow a firm grip. I end up having to push and pull the bolt handle near the middle of the stem, which I do not prefer. This bolt knob is the solution. It extends the length enough to allow me to grip the farthest out "knob" and run the bolt like normal. It is a much less invasive solution than cutting and welding a new bolt stem. When installed, there was a little wiggle, so I put a couple of pieces of electrical tape on the bolt knob and reinstalled the new knob and that tightened everything up nicely. I ding it one star, because it seems like it's overpriced by about $10 for what this thing is. There are a couple of polymer alternatives on the market, but they only make the bolt knob fatter but not much longer, so that wasn't going to help. Changing to higher rings would have necessitated a stock with a higher comb for proper cheek weld/eye alignment, so this thing seemed like the best solution.