Reviews & Ratings for ATN PS-22 Scope Mounting Systems — 10 reviews — Page 1

VERY NICE SETUP WORKS AS DISCRIBED. THESE MOUNTS ALLOW ME TO USE MY NIGHT VISSION ON ANY OF MY RIFLES. mAKES THE PS22 A VERY VERSITILE SYSTEM. ALSO THIS SYSTEM REQUIRES NO NIGHT TIME SIGHTING IN. DEFINATELY RECOMMENT THIS SET UP

The beauty of this setup is that it permits the PS22 to be placed on several different rifle scopes in a matter of seconds. The only item needed is high or extra high scope rings. It even fits one of my scopes without either of the two rubber adapter rings included.

I use this with an ATN PS22 on a Leupold VX3 scope with 50 mm objective lens. The device is easy to use and provides one the ability to mount the NVD on different weapons as long as the scopes' objective lens are the same size (or close). This mounting system provides a solid and stable connection between the NVD and the scope. The only down side is that the mounting device relies on plastic ring-shaped inserts to clamp down securely on the objective lens. These rings are split and tend to coil up as you place the proper one in the inner part of the mount. I found it challenging to mate the mount to the scope in under three tries because the insert ring would coil on me as I slid the mount onto the scope. I think I'm going to try some double sided tape to secure the insert ring to the mount - that should make the process of mating the mount to the scope a quick and easy process.

Good product and we've had no trouble with it after firing over 100 rounds with the NVD mounted to the scope using this device.

Pros: Easy to use; can be used on multiple weapons with same scope objective lens size
Cons: Expensive; uses plastic ring inserts that are easily dropped in the dark; ring inserts are split and have a tendency to coil inside the mount making it difficult to mate to the objective lens

Solidly built with a nice thread protector as well. Be careful with your selection of the adapter #. I bought the #6 for 62mm scope lenses, intending to use it on my nightforce nxs with 62mm objective. The inner diameter of this adapter (with plastic insert) is right at 62mm, but the outer diameter of the nightforce is too large, ~65 mm if memory serves. So to make this work, I had to remove the plastic insert and replace it with some thin gaffers tape (masking tape would probably work also) to keep from scratching the scope body. Without the insert, the inner diameter of this adapter is a hair over 65mm and makes a perfect fit on the nightforce. So be careful, the advertised dimensions seem to be for the scope body's overall diameter at the front objective, not the objective lens itself... at least in the case of the #6.
Pros: Solid construction
Cons: be careful w/ the dimensions!

My first thought was $100 for that? But it is well constructed and seems durable. I do have a few issues with it though, unless I'm just using it wrong. When you slide the adapters in they snap into place. Often when I try to mount it to the scope the ring slips out of place pushing it further down into the adapter housing. It is easily fixed and more annoying than anything else. My main issue is that I think it would be better to either send more adapters or have a "pick and choose" option.
Pros: Easy to use, quick, effective
Cons: insert rings keep sliding when trying to install.

THIS IS A WELL BUILT PRODUCT. VERY EASY TO USE. SELF EXPLANATORY. JUST FIGURE OUT YOUR OUTSIDE OBJECTIVE SIZE.
Pros: easy changes from scope to scope
Cons: i kit should cover all scopes

This is a must for the ps22, allows you to use with different scopes, easily can remove and replace quickly.
$100 a pop though can get expensive if you have different scope sizes.
Pros: EASE OF INSTALLATION,FUNCTION
Cons: VERY EXPENSIVE FOR THE ADAPTER,

When ordering make sure to know the out side diameter of your scope. Very easy to install.
Pros: Very well made
Cons: none