Reviews & Ratings for Breek Arms Warhammer Mod2 AR-10 / LR308 Ambidextrous Charging Handle

Breek Arms Warhammer Mod2 AR-10 / LR308 Ambidextrous Charging Handle

$74.99 $64.99 Save 13%

View Product

Write a Review

Compare (0)

Most Helpful Positive Review DOES NOT WORK WITH DIAMONDBACK DB10

Looks nice. Seemed well made. I bought one based on the expert response in the question section. He is wrong. It does not fit a Diamondback DB10. The handle is too long by at least a 1/4". Does not work for a DB10.

Most Helpful Negative Review Binds and Breaks

The charging handle itself looks nice but that is about where it ends. Somewhere between the 20th to 30th time I racked my AR-10 the aluminum snapped off just behind the gas block hole. The charging handle itself would bind constantly when pulled. You get what you pay for, lesson learned, don't buy ...
Read More...

Show

Sort by

Filter by

Sturdy Works well

by Frankie, from MD, United States Written on July 28, 2026

I got this as an OPMOD in Ranger Green and black for a first gen DPMS LR-308 and it’s been rock solid for over four years. I can charge from either side, either hand… even with heavy winter gloves charging is easy! This handle is ideal for use in freezing temps, easy to charge with numb hands in thick winter gloves. The retaining latch holds well but it does rattle around a bit but that’s the design.
This charging handle is the widest part of my rifle set-up, its 17mm wider than the caps on my optic, so I’m considering getting one with a smaller footprint…

Was it helpful to you? Yes | No

Check compatability before purchasing

by kikilqz, Verified Owner from FL, United States Written on July 25, 2026

I bought it for a DPMS AR10/308LR, and it is very tough to pull the charging handle. I had to polish it all the way around for the smoothest, and it just got a little, little bit better, but still hard to pull; literally, I need to pull it with both hands. It also feels a little rough in the fingers. The only pros on this is the price and looks nice, I haven't go to shoot yet and hopefully it gets better by time and use.

Pros:

Price
loogs good on AR

Cons:

hard corners, wear gloves
rough

Was it helpful to you? Yes | No

so far so good

by Felt, Verified Owner from VA, United States Written on June 20, 2026

Feels good n' solid. No gas to the face. Very solid charging handle for a fair price.

Was it helpful to you? Yes | No

Charging handle

by John Fava, Verified Owner from LA, United States Written on June 20, 2026

Everything went well. good service fast shipping!!! The product is really nice. The down side is that it didn't work in my PSA AR 10. It would not budge or cycle the rifle once I got it installed. I was disappointed. But it was caused by a faulty product!!!!!!

Was it helpful to you? Yes | No

Would NOT Buy

by Np, Verified Owner from GA, United States Written on April 30, 2026

The fitment was not great. Fired a couple rounds and it fouled up my upper.

0 of 1 found the following review helpful.

Was it helpful to you? Yes | No

Great product

by Jackal10, Verified Owner from FL, United States Written on April 29, 2026

I was having a problem with the existing charging handle on my Daniel defense DD5V4, I had my scope just where I wanted it but it was an issue grabbing and pulling it between the top of the receiver and scope, it was a hard pull and a difficult grab, so I replaced it with the Breek Arms Warhammer mod 2 AR 10, I bought from Optics Planet, at a great price and it was delivered quickly, and what a difference it made, the Warhammer has a wider handle and the pull is a breeze. I am very satisfied.

Pros:

None

Cons:

Best Used for:

All ARs

Was it helpful to you? Yes | No

55-FBS-PRSG3-MAG672-BLK

by Vinh, Verified Owner from AZ, United States Written on April 22, 2026

Fit in psa a10 good, and cheaper than radian chargers.

Was it helpful to you? Yes | No

Great Product

by Tony Rzasa, Verified Owner from GA, United States Written on April 7, 2026

Easy to manipulate with great lockup. The ambidextrous handle is easy to grasp and pull. The 7075 aluminum is stout with no flex.

1 of 1 found the following review helpful.

Was it helpful to you? Yes | No

BA Warhammer AR-10

by JM, from PA, United States Written on March 31, 2026

Great upgrade from MilSpec. Needed something I could easily get ahold of because of my optic. This was exactly what I needed. Allows me to get a good hold on it. Definitely an upgraded worth doing. Solid construction, easy smooth release.

Pros:

Afforable, great quality
light weight, but solid
tectured large levers
larger optic friendly
keeps gas out of your face

Cons:

I don't have one one every gun...Yet!

Best Used for:

anything, especially with large optic or wearing gloves

Was it helpful to you? Yes | No

Breek Warhammer Mod2 AR-10/LR308 Charging Handle

by BR, Verified Owner from MI, United States Written on March 10, 2026

What's not to love?

- Swaps out perfectly with milspec charging handle
- Oversize, serrated handles work well even with gloves
- Ambidextrous
- Relatively inexpensive but well made
- Made in America

Was it helpful to you? Yes | No

There are no reviews that match your criteria. Would you like to review this product?

FREE SHIPPING on Over 250,000 Products

Enjoy our FREE RETURNS

Reviews & Ratings for Breek Arms Warhammer Mod2 AR-10 / LR308 Ambidextrous Charging Handle — 112 reviews — Page 1