Your Browser is OutdatedReviews by Bill
Nice slide, minor mod required
Written on May 02, 2025
I really like this slide.
The the recoil spring assembly/guide rod hole on the end of the one I received was too small for my stock Glock RSA. The hole was 0.375" and is 0.420" on the stock Glock 43x slide. I'm not sure if it was a one off mistake or if they intentionally made it this way for some reason. Either way it was a non issue for me because I just bored it out to 0.420" and it works great. You can probably just open it up with a 27/64 drill bit but I wanted to be more precise so I indicated and bored it on a Bridgeport mill.
All of the other stock Glock internals fit nicely without an issue.
The the recoil spring assembly/guide rod hole on the end of the one I received was too small for my stock Glock RSA. The hole was 0.375" and is 0.420" on the stock Glock 43x slide. I'm not sure if it was a one off mistake or if they intentionally made it this way for some reason. Either way it was a non issue for me because I just bored it out to 0.420" and it works great. You can probably just open it up with a 27/64 drill bit but I wanted to be more precise so I indicated and bored it on a Bridgeport mill.
All of the other stock Glock internals fit nicely without an issue.
1 of 2 found the following review helpful.
There are no reviews that match your criteria. Would you like to
reset filters?