Billy Y from United States, WI Public Profile

This was my second choice after I was unable to get a Crossfire II Straightwall from OP for months.
Took it out to the range, zeroed in at 100yds and was pleased with the results. I got about 1.5 moa but I'm sure I could get it down to 1 if I was more patient. Eye relief is good and glass is clear. It fit my 1" Vortex scope rings and apparently is 3oz lighter than the Crossfire. Do not hesitate buy this.

I bought a Liteslide 17 to finish an SCT frame that I was building and it fit just fine. The serrations are grippy and the extra machining is very attractive to look at. It comes with multiple optics plate attachments for different footprints, but I didn't try any of them. So far, after 200 rounds, the finish is holding up very well and it ran with only one stovepipe malfunction.
I will say that the slide came in with smudgy fingerprints all over it. I'm not sure whether this came from the factory or if this may have been a return that came to me, but there were no other issues or signs of wear on it. The dovetail sights I bought for it also were impossible to put on with my sight pusher and required a trip to my gun store to push on with theirs. I have no idea if the issue was the Zaffiri rear sight or the slide, but it was not easy to pair the two.

I used these spacers to try and fit APX A1 FS mags in the APX A1 Compact and they do not fit the gun. The spacer is maybe 1/8 of an inch too long to fit the mags in the A1 Compact. The nomenclature being used for these guns are confusing and the descriptions for these spacers are very vague. This will probably fit the A0 compact, but not the A1 compact as it is the same size as the old APX Centurion, so you will need the C spacers.