burizoon from United States, FL Public Profile

I love all the pacesetter dies i have.
These are not any different. They work great and do the job right.the package contain the shell holder, dies ,manual, powder measure stick, in a nice plasic case.

I purchased few of these to have a nice OEM weatherproof storage for the dies installed in the turret. As there can be a year between the uses of the dies i need the storage container need to be sealed from external elements, like dust and humidity.
So now the bad things:
the 4 hole turret does not fit into the container without forcing. Spec said it should fit; well it does not.
It is not enclosed container. The holes for dies are open to outside.
There is only 3 holes in the container base and i tend to have 4 dies in the 4 hole turret.
The dies do not fit into the holes.
It is possible that i am not using the container correctly, but no manual was provided.
For my purposes this container is worthless.
My sollution is a big jar from peanut butter. The turret with the dies installed fit in. It is sealable, so when i store the dies i spray the dies with remoil and throw a small sillica desicant bag in the jar. The jar is big enough to fit the shell holder, manual for dies and the powder measure stick.
Value wise, the peanut butter jar is $3, gives you 2 months of delicious breakfasts and works better.
I love lee precision products,but this one is not up to paar.

I like the tool. I use it to bevel the edge of the primer pocket. Some brass has the crimp marks, from military required primer crimp leaving usually 3 crimp marks. This toll does that quick and easy.couple seconds and the brass is ready for repriming.

This pocket cleaner works great to remove the baked on deposits from primer. It wil not leave the hole polished, but that is not necessary. I tumble before bepriming to avoid stuck media in the flash hole. This tool does the cleaning of the pocket hole fast and easy
Only thing i wish would be added is a little sud in the center that would go into the flash hole and do a rough clean of it
I really like it. It only takes a second to clean the pocket.

If you have 4 hole turret press from lee, I highly recommend you getting one of these turrets for every set of dies you have. I leave the dies in the turret, where they are ready for next loading and you can skip setting up each die. you can swap the turrets in 2 seconds and you are ready to load different caliber. great time saver. I hold opinion of "if it is good do not mess with it", and once I am producing the reloads I like I want them all be the same, and this can make it happen.
I automatically add one of these to every order of new dies.

same goes for the 3 hole extra turret for the Lee 3 hole turret press.