Citizen from United States, WI Public Profile

This mount is solid and return to zero is great. 4 stars because the description does not address cowitness at all at time of writing.

For others who are reading, an eotech will not cowitness at all with standard iron sights on an ar platform using this mount.

Other than that though its nice. Should be advertised as more of a "riser" type mount or at least indicate the height in the specs.

The mount itslef is excellent, packaging is great, will definitely buy another adm mount when I need one.

Looks good, functional, shotshells are a very tight fit but assuming they will loosen a bit over time. Purchased because i didnt want to do any kind of permanent shell holder install on my 1301, and also because i use these as slimg mounting points on all my shotguns. Works great.

The wilson combat grip module is, dollar for dollar, the best improvement that one can make on any p320 or p250. I'm actually running this on my very old but loved sig p250 and it's the best. The price point, in my opinion, is outstanding.

It is Meg tech 124 as advertised. It's nothing special but it's good practice ammo. I've never had problems with magtech ammo. Came wrapped in Saran wrap so that boxes would not break open that's a nice touch.

I think this light is decent, but the mounting is a little outdated imo. With rails typically moving away from pic to mlok or keymod, this light requires a small section of pic rail be added to the firearm in order to mount. Which is fine but it detracts from the streamlined appearance by moving the unit further away from the rail than what is intended. Im hoping inforce could make an mlok version or better yet an mlok adapter.

The switch is a little mushy. As such i threw this on a lighter weight 9mm build that I'm not relying on for home defense. It's a decent light though i just think for the price the streamlight options are all around better.

My first folder build, and its a bufferless system so this was perfect. I will say that i took off a star as I hope a potential gen 2 would come with an endplate that doesnt have the "notch" that is on most end plates. The end olate is needed to retain the takedown pin detent and spring. Standard end plates wont work with this due to the notch that normally rides in a buffer tube channel. My solution was to dremel that notch off of an end plate and it works great, just wish matador would consider including an end plate in future generations of this adapter. Alternatively, machining the adapter with the necessary channel to index to a standard end plate however i think including a notchless end plate would be a simpler and cheaper solution. Install is simple and it locks up nicely. Love the ability to choose which side it folds to.